Skip to content

From heart pine to plank

Flooring Installation in Social Circle, GA

Social Circle has a historic core and a large number of newer houses, and the right floor depends heavily on which of those you live in and what is underneath.

Social Circle at a Glance

Location
39.5 miles east of central Atlanta (straight line)
County
Walton County
Population (2023 estimate)
5,330
Housing units
1,877
Median year homes were built
1995
Owner-occupied homes
78%
Detached single-family homes
91%
Built before 1970
22%
Built 2010 or later
15%

Sources: US Census Bureau 2023 Gazetteer, Vintage 2023 population estimates, and American Community Survey 2023 5-year estimates for the place. County is taken at the place’s center point; some communities extend into other counties.

Map of the 40-mile radius around Atlanta with Social Circle marked.
Straight-line 40-mile radius measured from the city center. Map outlines: US Census Bureau.

One small city, three different flooring problems

About 91% of homes in Social Circle are detached single-family houses and about 78% are owner-occupied, both well above the figures for nearby Covington and Monroe. In a place like this, a floor is usually a long-term decision made by the person who will walk on it. What varies is the house. Census estimates show 13% of homes from before 1950, another 9% from 1950 to 1969, 24% from 1970 to 1989, 40% from 1990 to 2009 and 15% since 2010, with a median year of 1995.

Those numbers split the question of flooring installation Social Circle GA owners face into three fairly distinct situations: a truly old house with original wood or layered coverings, a middle-aged house with worn carpet and sheet vinyl, and a newer house where builder-grade material is the issue. Each has its own risks. Picking a product before you know which group you belong in is how people end up with a floor that squeaks, gaps or fails at the seams.

The town is small, around 5,300 residents, and sits about 40 miles east of central Atlanta at the outer edge of the area we serve. Most of it lies in Walton County, with part extending into Newton County, says this general overview. That detail matters later if you ever need a county office, although flooring on its own rarely gets that far.

If your house is in or near the historic district

The Social Circle Historic District was listed on the National Register in 1980, along Georgia Routes 11 and 229, with Greek Revival, Early Commercial and Late Victorian styles named in the listing. A general reference gives it 132 acres and 200 contributing buildings. Not every old house is inside those lines, but the older housing in town is where you are most likely to find old wood floors under whatever came later.

Find out what is there before deciding anything

Lift a floor vent cover or pull up a corner of carpet in a closet. Old wide or narrow boards may run beneath several later layers. If they are sound, restoring them may be a better choice than covering them, and a floor finisher can tell you how many sandings they have left. Once wood has been covered in glue or tack strips for decades, the repair list gets longer, and it is still possible that patching is sensible.

Two materials that call for a pause

Old resilient flooring is the first. EPA lists vinyl floor tiles, the backing on sheet vinyl and adhesives among the materials where asbestos may be found, and notes that exposure generally comes when such material is disturbed during home repair or remodeling. If you find old tile, sheet goods or black mastic, do not sand or scrape it. Have a sample tested first. Sometimes the answer is to leave it undisturbed and go over it, which depends on floor height and the condition below.

Old paint is the second. Some early floors and many baseboards were painted. EPA estimates that about three quarters of homes built before 1978 contain some lead-based paint, and its renovation rule covers paid work that disturbs painted surfaces in those homes. Removing shoe molding or sanding a painted floor counts as something to raise with whoever does the job.

A further note for houses inside a designated area: interior floors are usually not what historic review focuses on, but we would not treat that as a rule. Confirm with the city if your project also touches anything on the outside of the building.

Middle-aged houses: 1970 through the 1990s

The largest group of older floors in town is probably here, simply because nearly a quarter of the homes went up from 1970 to 1989 and many of the 1990s homes followed. By now, many have been through at least one flooring change. Typical things to check:

  • How many layers exist? Each adds height, which can make doors bind and create awkward transitions.
  • Do subfloor panels squeak or dip? Fixing that means pulling the old floor, and it is the one chance you get to do it cheaply.
  • Is any of the subfloor stained around a toilet, tub or dishwasher? A water problem needs attention before new material goes down.
  • Are kitchen cabinets and appliances set on top of the old floor? That affects how a new one is fitted and whether a dishwasher can still come out later.
  • What is below the floor? A crawl space, a slab and a basement each call for different moisture checks and sometimes different products.

Crawl space homes need particular care. Wood responds to humidity, and any damp space under a floor can eventually show up above it through cupping or gaps. EPA’s moisture guide recommends keeping indoor relative humidity below 60%, and fixing water sources before anything else. So if a crawl space has standing water or wet insulation, handle that first. New planks will not hide it for long.

Newer homes: builder-grade carpet and thin vinyl

With 15% of homes built since 2010 and many more from the 2000s, a lot of owners here are looking at the first replacement of original materials. Their subfloors are usually in decent shape, though not always flat. The common request is getting rid of carpet in main living areas and putting one continuous floor across the ground level. That sounds simple, and it mostly is. Continuous runs do need some thought, however, about expansion gaps, doorway transitions and which direction the planks should run through a long room.

This is also where LVP and ceramic tile compete most directly, so here is a straight comparison of the two.

Choosing a material, room by room

Kitchen

LVP is forgiving underfoot and handles spills if seams stay tight. Tile lasts for a very long time but is hard on dropped dishes and tired feet. If the cabinets are being replaced, install flooring in the order the cabinet plan calls for.

Full baths

Tile is the traditional choice, and a waterproofing plan around the shower matters more than the tile itself. Vinyl planks rated for wet rooms can work well in a secondary bath that sees light use.

Living areas

Long, open rooms suit plank flooring. Sunny rooms can make some vinyl products expand, so ask about the manufacturer’s limits, particularly with big south-facing windows.

Stairs

These are the slowest and fussiest part of any flooring job. Vinyl stair nosing, retreading in wood or keeping carpet on the stairs alone are all reasonable, and the budget often decides.

Laundry and mudroom

Pick something that tolerates an occasional leak, and leave access to the shut-off valves. A washer hose failure is the classic reason these floors need replacing early.

Bonus room or attic space

Upper rooms over a garage can run hotter and colder than the rest of the house, so thermal movement and the condition of the subfloor deserve a look before buying material.

If the floor is one piece of a bigger plan, sequence matters. Painting walls first, then installing the floor, then touching up baseboards tends to save work, so it often makes sense to line up interior painting and drywall repairs ahead of time. Our main flooring page lists what we install.

Prep work that decides how long a floor lasts

Most floor failures are really preparation failures. New planks telegraph bumps in the subfloor and click joints can pull apart over a dip. Tile needs a rigid base, or grout and tiles will crack over time. A manufacturer’s instructions generally spell out flatness tolerances, moisture limits and how long material should sit in the room before installation, and following those is what the product’s maker expects.

Ask whoever installs your floor these plain questions. How will you check that the subfloor is flat? How will you test moisture, particularly on a slab? Who removes the old floor, and is its age a concern? What happens to baseboards and door casings? Are furniture and appliances being moved, and by whom? A written scope should answer each one, and ours sets out both the work and the price before anything starts.

Budget for the small things that come with the floor. New baseboards or shoe molding are often needed, doors may have to be trimmed, and transitions to tile or carpet need planning. Buy some extra material for cuts and keep a spare box, since a discontinued color cannot be matched a few years on when one plank is damaged. Old wood floors have their own version of this: patching with reclaimed boards may mean searching for a matching width and species.

Permits are rarely part of a flooring-only job, but they may be if subfloor framing, plumbing or a wall is changing. In those cases, the city’s zoning and building permits page is where to begin. Published permit guidance lists Community Development on North Cherokee Road as the office handling permits, so please confirm that directly with the city.

Owners in nearby Covington and Monroe will find some of the same older-house questions, though their housing mix is different. If you would like a free estimate, you can reach us through the estimate request page, and we will ask about your subfloor before we talk about product.

Sources for Local Facts

Let’s Build Something Great Together.

Ready to start your next construction or remodeling project? Tell us about your space and request a free estimate.

Nashville (615) 478-5705Atlanta (770) 669-1314